With special insulating and framing techniques, your basement will be as comfortable as any other room in the house. Framing the basement ceiling and wall is at the core of the basement finish project.
Planning and Getting Started
The basement can be more than a storage or utility area. With some good techniques and forethought, you will be able to make it warm and comfortable. It will be inviting like the other rooms that are in the house. However, you shouldn’t make any mistake when you do this. Take a looks at the steps to have the best basement finishing Toronto.
Insulating Basement Walls
You have start with gluing the extruded polystyrene foam insulation so that it fits against the foundation walls and rim joints. Make sure that you avoid expanded foam insulation when you insulate the basement walks as it is not as durable and also has a lower R value. You need to make a snap by cutting the chalk lines for marking and then scoring it with the help of a utility knife. Cut around the obstructions and fill up the spaces with smaller chunks of foam whenever you need it.
The caulk gaps and seems between the foam and the framing along the rim joist with more foam for sealing it against air leak and filtration. You can add fiberglass in later stages for a higher R value. The foam helps in reducing the heat transfer through the masonry and framing. This gets rid of the requirement of plastic moisture barrier later on. Make sure that you use adhesive formulated for using with foam when you insulate the basement walls.
Cut the Top and Bottom Plates
Snap chalk lines four inches away from the insulation on exterior portion of the wall. Thereafter cut 2×4 top and bottom plates and lay our stud locations in every 16 inches on each of the plate as you insulate the basement walls.
Anchor Bottom Plate
Squeeze a ¼ inch bead construction adhesive to your bottom plates and then position them accordingly. Thereafter, you will have to pre-drill with the help of a hammer and anchor it with concrete screws.
Nail a 2×4 blocking in every 3ft into the first floor of the joist for supporting the top plates to get best basement finishing Toronto. After this, you have toe-screw it to the rim joist to continue with the insulation of the basement walls.
Install the Top Plate
You need to plumb from the edge of the bottom plate with the help of a straight 2×4 and level. Snap the chalk line and then screw the top portion of the plate to the blocking with 3 inches screw.
Install the Studs
Make sure that you measure between the plates at every layout to make the best basement finishing Toronto. You need to mark and cut each of the studs to length. Toenail the studs into position that is at the bottom and the top with the help of 2 8d nails on one side and then centering the third on the other side. For more Info about best basement finishing read this article!